Fire, gas and carbon monoxide detectors
-
Jablotron JA-110ST BUS combined smoke and heat detector
Jablotron JA-110ST BUS combined smoke and heat detectorThe Jablotron JA-110ST BUS combined smoke and heat detector detects fire inside a building. The detector has different settings such as: smoke and heat, smoke or heat , smoke only or heat only. It has an alarm memory function where the LED will still be on after the alarm status is over. It is possible to assign the detector to a zone and it occupies only one position in the alarm system. SMART MEMORY indication (SMI) provides a visual LED verification of an activated detector. SMI can be disabled using the code control panel.Product Info
€103,38
-
Jablotron Ei208W stand-alone CO detector
Jablotron Ei208W stand-alone CO detectorThis CO detector can be connected to the Jablotron 100 using the JA-150G-CO module. The detector is certified for use in buildings, caravans and boats. The detector indicates excessive carbon monoxide concentration both optically with an LED and acoustically using a built-in siren.The detector is powered by an integrated lithium battery.Product Info
€165,06
-
Jablotron JA-111ST-A BUS combined smoke and heat detector with fire and burglary siren
Jablotron JA-111ST-A BUS combined smoke and heat detector with fire and burglar siren functionThe product serves to detect fire hazards in the indoor areas of residential and commercial buildings. The detector is not intended for installation in an industrial environment. The detector is powered via the control panel bus. When the detector is used with batteries (3x 1.5 V AA), with which it can be powered, it will continue to function as a stand-alone detector when the 12 V power supply is disconnected (EN 14604).The smoke detector has a built-in siren that signals fire and burglary alarms. This notification is taken over by all detectors in the system!The detector indicates fire danger using the built-in LED indicator and acoustic signaling.The JA-111ST-A product consists of two independent detectors - an optical smoke detector and a heat detector. The optical smoke detector works on the principle of scattered light. It is very sensitive to coarser dust particles present in dense smoke. The product is less sensitive to smaller particles generated by combustion of liquids such as alcohol. Therefore, the fire detector also includes a built-in heat detector, which is slower to respond, but better able to detect a fire , which generates only a small amount of smoke.Product Info
€123,81
-
Jablotron Ei208DW stand-alone CO detector with display
Ei208DW stand-alone CO detector with displayThis CO detector can be connected to the Jablotron 100 using the JA-150G-CO module. The detector is certified for use in buildings, caravans and boats. The detector gives excessive carbon monoxide concentration both optically and acoustically an LED and acoustic signal using a built-in siren. This model also shows concentration data on the display.The detector is powered by an integrated lithium battery.Product Info
€218,91
-
Jablotron JA-110G-CO Connection module
Jablotron JA-110G-CO Connection module The Jablotron JA-110G-CO Connection Module is a plug-in module intended for direct installation in a stand-alone Ei208W or Ei208DW CO detector, allowing the connection of the bus to the JABLOTRON 100 system. Product Info
€45,59
-
Jablotron GS-208-CO Connection Module
Jablotron GS-208-CO Connection module The Jablotron GS-208-CO Connection Module is a plug-in module intended for direct integration into the stand-alone Ei208W or Ei208DW CO detector, allowing the wired connection of the bus to a security unit or other system.The module provides galvanic isolation of the wired output of the entire detector. It provides the control panel with information about alarms and detector errors. Product Info
€49,51
