Service instructions for JA-111I
BUS LED indicator RGB
This product is a component of the JABLOTRON JA-100 alarm system. It serves for optical indication of the status. The color of the indication is optional through the connection, for example, the indicator can indicate the operated output in two colors (red / green). The product is intended to be installed by a trained technician with valid Jablotron certification.
Installation
1. Open the indicator cover by loosening the four snap clips using a suitable flathead screwdriver, turning in the direction of arrows.
2. Loosen the snap clip (1) and remove the plate.
Illustration: 1 - clip of the plate; 2 - indicator light; 3 - open hole for supply cable; 4 - connection terminals
3. Pull the supply cable through the created hole (3) and attach the indicator's back panel at the selected location.
4. Snap the indicator plate back in.
5. Connect the cable to the terminals (4) according to the selected color for indication by signal light (2), see table:
+U supply of voltage of 12 V
R red light, if connected to GND
G green green light, if closed on GND
B blue blue light, if closed on GND
Y yellow light, if closed on GND
6. After turning on the system, test the operation.
7. Put on the indicator cover.
Function
The indicator is designed for indication indoors, also outside the monitored space. If it is installed outside the monitored area, the voltage conducted at +U terminal (if tapped from the BUS of the system) must be protected against short circuit, e.g. with a JA-110T module of the bus isolator.
Figure: example of connection for a two-color indication of status of the PG output
Figure: dimensions of a JA-111I indicator.
Technical parameters
Power supply 12 V (9 ...15 V)
Current consumption in standby mode (LED on / off) 5 mA / 0 mA
Current consumption for cable selection 5 mA
Dimensions 62 x 36 x 27 mm
EN 50131-1 II. indoor environment, general
Operating temperature range -10 to + 40 °C
Remark: Although this product does not contain harmful materials, do not dispose of it in the household waste, but dispose of it at the collection point designated for electronic waste.